Dry mortar equipment with diverse raw materials, safe and environmentally friendly

Dry mortar equipment with diverse raw materials, safe and environmentally friendly

Dry mortar is mainly composed of cement, dry sand, fly ash, thickening powder and other raw materials. Special process mortars also require a small amount of additives such as cellulose ether, which are stored in storage tanks for production and use. The wet sand is first sent via a conveyor belt to a sifter for sieving and then dried via a conveyor belt in a three-way dryer to be fed into the drying line.
There may be certain safety hazards in the production of dry mortar production lines, and users need to take early precautions to ensure safe production.
Dry mortar production line self-contained brick machines, liquid pressed brick machines and other high altitude rotating belt open cockpits should use safety belts. The belt width should be approximately 50 mm. Nylon braid should be used. Do not use cotton belts, plastic belts or artificial belts. Belts. The first three are weak and easily damaged, and belts can easily deform and break after rain. The seat belt should be secured to the brick machine in two separate sections and the method of securing must be reliable.
If the safety belt is fixed in a steel cockpit, the fixing parts must have steel plates or buried metal elements to ensure their strength.
This type of safety bar can be used as a safety bar or handrail. Locking levers have a variety of locking forms and can be either a convenient latch type or a spring-loaded tap type similar to a door lock. The spring impact firing pin is formed in a wedge shape and can be inserted into the hole after the stop has been pulled into place.
The slow loading of insulated mortar equipment will directly affect the productivity and output of the equipment. So why is slow feeding of insulating mortar equipment? We believe that slow material loading may be related to the hoist or the material itself.
It could be because the motor and hoist are not running at the correct speed. This is most likely if the insulated mortar equipment is purchased new. The drive structure inside the old insulated mortar equipment may be damaged, with a large spiral gap and probably the most normal wear and tear.
Secondly, it may be due to a problem in the production process, firstly with light materials, after heavy materials, or with materials, mixed with heavy and new materials, loading fast, which is normal, and should be insulated with mortar equipment. If the fault is different, it is best to add baffles to change the size of the loading opening if the opening below the hopper is too large.
It may also be due to the loading hoist of the insulation mortar equipment having too much slope, usually no more than 60°.