Mortar equipment must clean the inside of the drum with water and dry it after use

Mortar equipment must clean the inside of the drum with water and dry it after use

Mortar equipment construction, construction units should be suddenly cooled down, the construction period should be taken during the construction of emergency measures: mixed mortar materials should be heated, the water temperature should not be higher than 60 ° C, the temperature should be higher than 60 ° C. Mortar should not be lower than 10 ° C. Mortar mixing speed is closely related to the progress of masonry, can be mixed. Finished components should be covered with insulation and should not be maintained with water at temperatures below 5°C. There are many issues to be aware of when working with mortar equipment during the winter months. I hope this information will help everyone. Maintenance of mortar equipment is also very important. Mortar equipment is a high frequency equipment and even some companies use it constantly 24 hours a day. It is very important to maintain the equipment. Let's talk about a few areas that need attention during maintenance.

Please note if the fasteners are loose after the mortar equipment has been used and tighten them in time. Mortar equipment will be used with a working platform and solid parts should be checked regularly. Mortar equipment should be placed dry and must not have any dry corrosive media where? In terms of environment, to ensure the normal service life of mortar equipment, mortar equipment is generally made of carbon steel and sprayed with a layer of anti-rust paint. If placed in a corrosive medium for a long time, it can easily rust.
After using the mortar equipment mixer for a period of time, check the level of lubricant. Add oil to the observation hole, oil 30#. The lubricant is an important part of the machinery and equipment. If the lubricant is not replenished in time it may lead to wear and tear of the drive components, so check the lubricant regularly.
Always wash the inside of the drum with water and dry it after using the mortar equipment. Over time, users have been able to prevent rusting oil on the same surfaces and on the blade surfaces. If the material on the mixer blades is not cleaned, it will be difficult to clean after long periods of inactivity and the mixing efficiency will be affected by the mixing efficiency and homogeneity. Never put nails, wire or other hard objects into the cement and sand during feeding as this may damage the machine. Sift the material before feeding to ensure there are no other impurities.