Dry mortar equipment belt loosening feeding speed will slow down

Dry mortar equipment belt loosening feeding speed will slow down

When using dry mortar equipment, we usually need a speed that affects the output. If there is a slow and abnormal feeding speed, what should we do? Let's analyze it together.
1. The feeding speed of dry mortar equipment is slow. We can first consider whether the belt is loose. If it is loose, it will cause sliding and affect the feeding speed.
2. It may also be because the bearings of the dry mortar equipment are increased into powder, the bearings below can easily enter the powder, increasing the friction and affecting the efficiency of work, or it may enter the foreign matter, which can easily enter the blockage and affect the loading.
For these common reasons, we recommend that you add lubricant promptly during use and check regularly to ensure smoothness. Also, if not loading a newly purchased unit, we need to check the direction of rotation of the motor. If this is because of the direction, please adjust it. Often it is not installed correctly and is not feeding properly.
Do you know the importance of electric drives for dry mortar equipment?
When the dry mortar plant is producing properly it can use enough drive to improve efficiency and increase production, so it is often important to check that there is enough electric drive. When dry mortar equipment is working properly, the power supply should not be lower than the nominal input voltage of the dry mortar equipment. In fact, the transformer is built into the dome and the transformer supplies the power after the transformer has been converted. With limited space inside the dry mortar equipment, the built-in transformer makes the strong and weak power coexist, thus affecting the weak signal. In addition, the built-in transformer increases the burden of heat dissipation and increases the likelihood that the built-in circuitry will deteriorate.