Lubricant for machinery and equipment is a very important part

Lubricant for machinery and equipment is a very important part

Dry mortar equipment manufacturers equipment belongs to the high frequency use of equipment, in the dry mortar enterprises are very widely used, some enterprises are even 24-hour non-stop production, so the equipment to do routine maintenance to ensure the normal operation of the equipment in production. With the gradual arrival of winter, the temperature gradually decreases, and the lines of dry mortar equipment may also be frozen hard leading to breakage, especially in the colder areas of the north. Therefore, the daily maintenance of the dry mortar equipment is an important daily work, each shift of workers after the completion of production should be strictly enforced, equipment in the daily maintenance to pay attention to the following aspects

Often pay attention to whether the fasteners are loose after use, tighten in time. Large dry mortar equipment will be used to work platform, should be regularly checked solid parts. Feeding is strictly prohibited in the cement and sand caught in nails, wire and other hard objects to avoid damage to machinery. The material should be screened before feeding to ensure that there are no other impurities. Dry mortar mixer reducer box after a period of time, to check the level of its lubricant level, timely replenishment to the observation hole can see the oil surface, the oil quality of 30 # mechanical oil. Lubricating oil for mechanical equipment is a very important part, if the lubricant is not timely replenished may cause wear and tear of the transmission parts, so check the lubricant regularly.

Dry mortar equipment should be placed in a dry and non-corrosive environment to ensure the normal service life of dry mortar equipment, dry mortar equipment is generally made of carbon steel and sprayed with a layer of anti-rust paint, if placed in a long-term corrosive medium environment or easy to rust. Dry mortar equipment must be used to finish the barrel and mixing leaves with clean water scrubbing and dry, long-term non-users can be in the same inside and blade surface on the anti-rust oil. If you do not clean the material on the mixer leaves, long-term idleness will be difficult to clean after clumping, and then the mixing time will affect the mixing efficiency and uniformity.

Dry mortar equipment normal production, get enough drive, can strengthen its effectiveness, increase production, so often test whether there is enough power drive is particularly important. Dry mortar equipment works normally, the power supply should not be lower than the nominal value of the input voltage of the dry mortar equipment. The actual quality will be transformer built into the dome, after the voltage change to dry powder equipment power supply. With limited space inside the dry powder equipment, the built-in transformer makes the strong and weak power co-located, thus affecting the weak signal. In addition, the built-in transformer increases the burden of heat dissipation, thus increasing the likelihood of burning out the built-in circuitry.

Has sufficient electrical drive been obtained? This can be tested with a multimeter by using a multimeter to measure the voltage of the power line at one end of the dry powder equipment with the dry powder equipment on and observing whether the voltage is within the permitted range of the dry powder equipment. It is particularly important to note that the power consumed by the outdoor dry powder equipment differs greatly when the heater is started or rested, and that the outdoor dry powder equipment should also be fitted with external lightning protection measures in particular. Generally speaking, the outdoor dry powder equipment casing mounted on a pole stand is naturally grounded and protected because it is screwed to a metal stand, so no special treatment can be done.