Dry mortar equipment built-in transformer makes strong and weak power coexist

Dry mortar equipment built-in transformer makes strong and weak power coexist

When dry mortar equipment is produced normally, enough drive can be used to improve efficiency and increase output, so it is usually important to check if there is enough electric drive. The power supply should not be lower than the nominal value of the input voltage of the dry mortar equipment for normal operation. In fact, the transformer is built into the dome and the transformer supplies the power after the transformer has been converted. With limited space inside the dry-mix mortar equipment, the built-in transformer allows strong and weak power to co-exist, thus affecting the weak signal. In addition, the built-in transformer increases the burden of heat dissipation and increases the likelihood of ageing of the built-in circuitry.

Dry-mix mortar equipment layout reference.
The tower process layout is usually configured from top to bottom, followed by the sand sifter, storage tank, feeder, metering drum, mixer, packer and stacking conveyor. All pre-processed raw data, raw data will flow from the silo according to its own gravity and after being mixed by the computer is sent to the finished product warehouse, spiralled to the packer, or loaded onto the tipper truck. It becomes a commodity, with a brain control system, high compositional accuracy, sensitive application and closed production equipment, making the site clean and dust-free for purification.
Mixing tower dry mix mortar plant puts the sand box into the air, measures it and then lifts it by bucket elevator to the temporary storage box above the mixer, which is put into the mixer to stop the mixing. The screw weighing tube stops the cement, lime and other raw materials and stops metering. The small additives are still placed in the additive chamber located in the upper part of the mixer. This method is suitable for the production of all kinds of common dry mortars, special mortar products, equipment etc.
The tower type dry mortar production line has a high structural input and is suitable for the production of all kinds of dry mortars. In particular, the product is a single common dry mortar and special mortar. The equipment covers a small area, but the investment is large.
The simple dry-mix mortar equipment is suitable for the production of a single type of special mortar. Low investment and small footprint. Low degree of automation.