Dry-mix mortar equipment measures raw materials through data feedback from sensors

Dry-mix mortar equipment measures raw materials through data feedback from sensors

Dry-mix mortar equipment is mainly used for the production of dry mortar mixing. This equipment has three production processes. This is a short introduction to.

One horizontal process. The main reason is to lift the raw material into the silo for storage. After weighing the raw materials, they are sent to the mixer by means of horizontal conveyors, then mixed into the storage bins and sent out via a logistics system. It is used at the construction site.
The second is a vertical process. The process of dosing, mixing, packing and puffing is carried out sequentially by lifting the material from the top to the bottom into the silo.
The three tower process. The process uses a tower line with advanced dosing and central control technology such as air floatation and PLC. The material flows mainly according to its own gravity and each production process is carried out automatically.
There are many ways to measure and batch dry mortar equipment. A good performance is the screw conveyor. The dry mortar plant is suitable for all powder materials in mortar. With frequency control, high precision in horizontal arrangement and long service life, the dry mortar production line has an annual capacity of 20,000 to 30,000 tons. In this case 4-6 raw material tanks will be used, two large tanks for bulk cement and fly ash and smaller tanks for light calcium, heavy calcium, sand, small materials etc.
Bulk cement and fly ash are not used in combination with measuring screws. The dosing system introduces the raw material from the silo into the measuring tank. The raw material is measured by means of data feedback from the sensors. The dry-mix mortar plant needs to be upgraded and pump trucks are used for entry. The dosing material enters the main hopper lifter via a screw conveyor and is lifted to the upper part of the mixer for mixing. When the mixing warehouse is of the pneumatic large opening type, the material to be mixed can be quickly placed into the gravity-free mixer for continuous production of dry mortar.
The dry mortar plant uses a twin-shaft paddle type high efficiency mixer that does not destroy the raw material state, dry sieves fine aggregates with cementitious materials, mineral admixtures and admixtures to mix. Proportions and build up. Only a certain amount of water needs to be added for mixing. Dry mortar plants are designed to suit the manufacturer's plant and investment size.