Dry-mix mortar equipment is designed according to the manufacturer's plant and investment size

Dry-mix mortar equipment is designed according to the manufacturer's plant and investment size

Dry-mix mortar equipment using dual-shaft paddle-type high-efficiency mixer, without destroying the state of raw materials, dry sieve fine aggregate and cementitious materials, mineral admixtures and admixtures mixed. Proportion and construction. Only the right amount of water needs to be added for mixing. Dry mortar plants are designed to suit the manufacturer's plant and investment size.
To ensure the safety of personnel during the production process, each dry mortar plant control switch must be protected from leakage. Non-specialist testing and maintenance of the equipment and commissioning work is strictly forbidden. After the dry-mix mortar equipment is started, attention needs to be paid to the working direction of the equipment and whether it conforms to the prescribed direction, otherwise it will cause damage to the dry-mix mortar equipment. After the equipment is put into use, the equipment must be maintained regularly to improve the efficiency and extend the service life of the equipment.

Dry mortar equipment should be installed in a location that is easily ventilated and dry, and the surrounding environment should be kept clean. Regularly check the tightness of the drive belt and the screws at the joints and make appropriate adjustments. The dry mortar equipment is a gap mixing unit. Please note that individual work loads should not exceed the specified number of units. Dry mortar equipment should follow strict air machine start-up.
There are many methods of measuring and batching dry mortar equipment. A good performer is the screw conveyor. The dry-mix mortar plant is suitable for all powder materials in mortar. It is frequency controlled, has a high accuracy of horizontal arrangement, a long service life and a dry mortar production line with an annual capacity of 20,000 to 30,000 tons. In this case 4-6 raw material tanks will be used, two large tanks for bulk cement and fly ash and smaller tanks for light calcium, heavy calcium, sand, small materials etc.
Bulk cement and fly ash are not used with the measuring screws. The metering system introduces the raw material from the silo into the measuring tank. The raw material is measured by means of data feedback from the sensors. The dry-mix mortar plant needs to be upgraded and pump trucks are used for entry. The metering material enters the main hopper lift tube via an auger and is lifted to the top of the mixer for mixing. When the mixing warehouse is of the pneumatic large opening type, the material to be mixed can be quickly placed into the gravity-free mixer for continuous production of dry mortar.