Operation of dry mortar equipment shall be in strict accordance with the safety operating procedures to operate

Operation of dry mortar equipment shall be in strict accordance with the safety operating procedures to operate

Dry mortar equipment belongs to the construction industry machinery, has a strict safety production standards, workers in the operation of dry mortar equipment shall be in strict accordance with the safety operating procedures to operate to avoid production accidents. Specific operating procedures are as follows.
A. Workers must check whether the rotation of the dry mortar equipment is good, safety devices, protective devices, etc. should be solid and reliable, flexible operation before operation.
2. After the dry mortar equipment is started, it should first run on empty, check whether the rotating direction of the mixing leaves is correct, and add water first and then add material for mixing operation.
Dry mortar equipment should not be operated with hands or wooden sticks into the mixing pocket or in the mouth of the pocket to clean the mortar.
When there is any abnormality or the temperature rise of the bearing is too high, the machine should be stopped for inspection; if the machine fails to operate and needs to be inspected, the power supply should be cut off first and the mortar in the mixing pocket should be poured out for overhaul and troubleshooting. Do not use tools to pry and other dangerous methods, forced mechanical operation.
Fifth, the mixing blade of the mixer and the mixing material pocket bottom and side wall of the interval, should always check and confirm that the provisions, when the gap exceeds the standard, should be adjusted in a timely manner. When the mixing blade wear exceeds the standard, should be timely repair or replacement.
Sixth, the operation is completed, do a good job of cleaning inside and outside the mixer and mixer around the clean-up work, cut off the power supply, mixer switch to play the lockout, hanging power outage sign; maintenance of the mixer, switch hanging "is overhauling, power supply is prohibited" sign, and send a person to monitor.
Seven, the parking location of the mixer should choose a flat and solid site, the mixer is installed smoothly and firmly.
Eight, dry mortar equipment operation while adding material and water, can not join the material and then start, feeding is not allowed to exceed the rated capacity. When adding material, tools can not collide with the mixer, not to mention the tools in operation into the mixer to grab the material.
Nine, dry mortar equipment, the hopper can not enter the debris, to remove debris to stop.
Ten, the work is completed to clean the mixer, the rotating part of the injection of lubricating oil, clean-up shall not make the motor and electrical damp.
Dry mortar equipment safety operating procedures are only some written form, to really avoid accidents must be made to safety awareness deep into the hearts of operating workers, from time to time to hold similar safety training, regular inspection of the operation of workers to avoid unsafe operating factors on the impact of production.
Dry mortar equipment is often used in the construction sector, where it enables building materials to be bonded and shaped.
Dry mortar equipment is used to produce dry mortar and the mixing system is the core system of dry mortar equipment.
How does the system of dry mortar equipment perform?
The performance of the mixing system of the dry mortar equipment is described as follows.
I The equipment uses high speed flying knives and efficiently dispersed fibres.
Two The equipment has a mixing uniformity of more than 99%, and can be mixed evenly in 1-3 minutes.
Three equipment has a unique mixing principle and mixer design, which can reduce energy consumption on the basis of achieving mixing quality and high efficiency.
The whole machine adopts gas seal, pneumatic large door, unique discharge device door, pulp leaf list plate wear-resistant design, long life, easy maintenance, reliable and stable.