Dry mortar equipment assembly process steps

Dry mortar equipment assembly process steps

The assembly of dry mortar equipment is an important issue. There should be no mistakes. Otherwise, it will cause unexpected failure of the dry mortar equipment during the working process, which will affect the normal operation of the enterprise and eventually cause certain economic losses. Presumably, this phenomenon is something we do not want to happen, so users should not only pay attention to the choice of dry mortar equipment, but also seriously face the assembly of dry mortar equipment, carefully check the details and ensure the overall quality of the equipment. Give full play to their strength and help users create value.
After the dry mortar equipment has been used for a period of time, the user will clean it systematically, so that each part of the equipment will be separated. After careful cleaning, the parts are cleaned and dried, and each part is assembled in reverse order. The bearings of the dry mortar equipment near the end cap section do not have straight slots and the bearings at the rear end of the bearings have straight slotted bearings.
Check and make sure that one side of the dry mortar equipment has a lot of welded carbide and then this side is the friction surface with the bearing. After assembling the rear side bearing and the thrust plate of the mixing body, the locking washer is locked and the inner surface of the thrust plate has a small chamfered surface. The surface should face the rear end bearing when fitted and then confirm that the cut out section of the sleeve The keys are aligned. Finally check the radial clearance or side clearance of the gear.
Careful assembly process, meticulous and thoughtful inspection, on the one hand, to protect the overall quality of dry mortar equipment, on the other hand, to protect the interests of users themselves, because only a production equipment with good quality and stable performance can work. In this process, we will exert the greatest strength to help the user to obtain greater benefits. Therefore, no matter how users must pay attention to the quality of dry mortar equipment, we must carefully check and keep every detail of the equipment.
Multi-functional dry mortar equipment is mainly used to produce construction mortar powder. Dry mortar is usually processed according to certain methods by means of dry sieves (e.g. quartz sand), inorganic cementitious materials (e.g. cement) and additives (e.g. polymers). The proportions are a physical mixture of granules or powders which are transported to site in bags or in bulk. After the addition of water, it can be used directly. Also known as slurry dry powders, dry mixes, dry mixes and some construction adhesives also fall into this category. During the production and operation of multifunctional dry mortar equipment, the following locations are prone to leakage: 1. At the raw material inlet, which is part of the bucket elevator, where powder leakage will inevitably occur due to direct contact with the raw material.
2. At the packer outlet of the production line. As the dry mortar is bagged packing machine, the packing machine will produce a certain amount of powder leakage when it is loaded, and powder leakage from automatic mass measurement packing machines is generally unreliable. Very serious.
3. waiting for the inlet mixing warehouse and dry mortar production line.
4. the entrance of the mixer, the entrance of the mixer is located in the production line. In addition to the above four aspects, the average large production line production process is closed production, the production process of powder leakage is less, generally speaking, the quality of dry mortar equipment is inevitable, some powder leakage will occur. When selecting multifunctional dry mortar equipment, the manufacturer allows or recommends dry mortar equipment within the range of purchasing power and productivity, ensuring on the one hand low material leakage and on the other hand, production and productivity will be increased.