Dry mortar equipment maintenance maintenance detailed steps

Dry mortar equipment maintenance maintenance detailed steps

In the dry mortar equipment, dry powder mixer, dry powder mixer and dry mortar mixer all use, we need to do a good job of maintenance and maintenance. So, in the actual maintenance process, have you done this?
Add water to the mixing drum for 1 to 2 minutes prior to your daily work. In this way, the reliability between the components can be checked. If not, it is very problematic if the equipment fails during actual use. Furthermore, it is advisable to check each lubricant as well as those circuits and control devices before use. If not, it has a great impact on our actual use.
At the end of your daily work, clean the device carefully and release any substances that have accumulated in the device in time. Please note that we can only work properly if the sensors return to zero properly.
What we also need to do after the daily work is to remove the air compressor from the equipment, the air tank and the water in these filters. If not cleaned in time, it can easily eat away at the corrosion of the salty equipment. These are very important for our practical use.
We need to pay attention to these during the actual maintenance of the dry mortar equipment. If we ignore the details of the problem, it will have a great impact on our actual use.
The dry mortar equipment feeder must be maintained regularly because it has a certain impact on the final production efficiency, so we cannot ignore it.
First of all, when the dry mortar equipment feeder is used for dosing and batching, in order to ensure the uniform stability of the feed and to avoid the automatic flow of the material, the installation must pay attention to the horizontal position, where the material is usually supplied continuously. It can be installed at an inclination of 10° downwards and can be installed for viscous materials and materials with a water content of approximately 15°;
Secondly, it is usually necessary to leave a swimming gap of approx. 20 mm in the installed feeder, the horizontal orientation should be horizontal and the suspension should usually be flexibly connected;
Thirdly, the fasteners must then be checked for looseness before operating the machine empty and need to be checked again after a period of continuous operation;
4. During the feeding process it is necessary to check the amplitude, current and noise stability frequently. If abnormalities are found, stop and check immediately;
5. In addition, it is necessary to pay attention to the lubrication operation.