Need to check the degree of tightening before using dry-mix mortar equipment

Need to check the degree of tightening before using dry-mix mortar equipment

Regardless of the purchase of any dry mortar equipment, the break-in period of the machine is very important. Just like people, if you just enter a new environment and need to constantly adapt and explore, then the process of contact will gradually adapt to the principles of the large group is consistent. A good machine break-in period depends on the output of the dry mortar plant and this directly affects whether the dry mortar plant will be able to operate consistently in the future. Any new machine purchased is not highly productive, but rather the machine runs through a break-in period of 1-3 weeks.
When starting to grind the dry-mix mortar plant, it is necessary to check the tightness of the dry-mix mortar plant beforehand and then note the normalcy of the sound of the gear meshing gears when no additions are required Any raw materials, as well as bearings and motors. The motor current should be kept within normal limits and not too high or too low.
After the dry mortar equipment has idled normally, the speed should be consistent when feeding the hopper just after opening, and the dry mortar equipment should be run for a test run. After 3-4 hours of repetition, the relevant parts of the machine are grounded to a good condition before production starts.
In the process of using the dry mortar equipment, the machine's operating status needs to be checked continuously. If abnormalities occur, the machine must be stopped at any time for inspection.