After receiving the dry-mixed mortar equipment should check whether the original parts of the electrical control box are complete

After receiving the dry-mixed mortar equipment should check whether the original parts of the electrical control box are complete

Dry-mix mortar equipment is produced by dry-mix mortar equipment manufacturers for dry mortar. Usually, customers can install small equipment according to the manufacturer's instructions. For the installation of large dry mix mortar equipment, such as hoists, working platforms, raw material tanks, etc., the manufacturer needs to arrange for dedicated installation. It is therefore the manufacturer's responsibility to check and accept the installation items of dry-mix mortar equipment once the installation schedule has been completed. Currently, all equipment installed requires the customer to sign an installation confirmation and collect feedback from the customer on this. The customer should refer to the following acceptance criteria to check the condition of the installation of the equipment
Check that the appearance of the dry-mix mortar equipment meets the requirements. The main checks are the paintwork, shape, etc., as the dry-mix mortar equipment is customised and does not exclude special appearance requirements of the customer. If the appearance is different from the original plan, the manufacturer must be contacted promptly.
Material testing machine. It is very important that the dry mortar plant is tested after installation. On the one hand, the test machine with the material will check the operation of the equipment and on the other hand, it will also check that the equipment is functioning properly. During the feeding of the test machine it is necessary to pay attention to the following facts: the test machine should not be fed with a large amount of material at one time, so that the car does not burn up due to a paper jam. A little material should be added, which can be seen as a kind of break-in of the equipment.
Check the integrity of the dry-mix mortar equipment. The main check is whether the support equipment of the dry mortar equipment is completely installed, such as the electrical control box, weighing equipment and other equipment is installed. It is important to check that the original parts of the electrical control box are complete to avoid problems when testing the machine.