The quality of the mixing effect of small dry mortar equipment directly affects the quality of the product

The quality of the mixing effect of small dry mortar equipment directly affects the quality of the product

Small dry mortar equipment in the production process encountered the problem of uneven mixing. The quality of the mixing effect directly affects the quality of the product, and also affects the sales performance and economic development of the user. However, there are two possible reasons for the uneven mixing of dry mortar equipment. One possibility is that when putting the material into the material, the user first puts water into the material. A common problem encountered in the problem may be due to the user's choice of mixing. Applicable to the machine, to ensure good mixing in small dry mortar plants, the user needs to not only arrange the materials in the normal order, but also choose the right mixer for the production needs.
In the production process of small dry mortar equipment, the production of mortar equipment may encounter lumps of raw materials. The reason for this may be condensation due to heavy mixing. Allow it to stand for two to three minutes and then allow it to loosen itself. Another cause may be that the raw material has been stored for too long and is subject to the external environment. A good way to solve the problem is to replace the raw material. It is important to keep the raw materials in production and to keep the storage space for them dry and ventilated.
A problem encountered in the production of small dry mortar plants is the difficulty of mixing. It is well known that the main function of dry mortar equipment is to mix the various production materials by stirring them. If mixing is not possible, then the dry mortar equipment will not use the waste equipment at all. There are two main reasons why dry mortar equipment is difficult to mix, namely the lack of power of the portable electric drill. One immediate solution is to replace the mixer with a smaller diameter mixer or a low speed mixer. The other reason is a lack of water, as long as production is based on production. Adding sufficient water in proportion to the mixer will allow the dry mortar plant to resume normal mixing.
Before starting small dry mortar plants, care must be taken to: first open the viewing ports, discharge ports, feed ports etc. of each plant to observe for residues and debris. If the dry mortar equipment is strictly removed before starting work, it is strictly forbidden to put hands, hard objects and debris into the equipment during the working period.
In order to prolong the service life of the small dry mortar equipment, the power supply of the dry mortar equipment should be earthed during operation. After turning on the mortar equipment, it takes 5 to 10 minutes for the warm-up machine to idle. No abnormalities were found in the warm-up machine before it was used for production.
To ensure the stability of personnel during production, each dry mortar unit is protected against leaks. Non-testing and maintenance of the equipment as well as commissioning work is strictly forbidden. After starting up the small dry mortar unit, attention must be paid to the working direction of the equipment and whether it conforms to the prescribed direction, otherwise the mortar unit will be damaged. After the equipment has been put into use, it is important to maintain the equipment on a regular basis in order to improve the efficiency and extend the service life of the equipment.