The correct use of dry mortar equipment

The correct use of dry mortar equipment

Dry mortar equipment use precautions, we refer to, after the installation and commissioning of equipment, the customer in the use of matters needing attention.
Top ranking, wrong start-up sequence, elevator ------ mixer ------ packer ---- air compressor, many customers, using dry mortar equipment to produce dry mortar are from scratch, that is, first open the loading machine, after loading, then open the mixer, and then the packer, in fact, this is not right, it is easy to cause motor burn, or bearing slip tile phenomenon, the reason is simple. to a ton of dry mortar equipment, for example, when we put a ton of dry mortar material into the mixer, and then open the mixer, at this time the resistance inside the mixer is suddenly increased, bringing a very fierce impact on the bearings, but also to the motor a great load.
Second, the normal start-up sequence, air compressor ----- mixer ------ hoist ------ packaging machine, mixer normal rotation, hoist lift material slowly join, mixer motor load is slowly lifting, will not bring damage to the equipment.
Third, the start-up airlift, is an essential detail for the maintenance of good dry mortar equipment, is to allow bearings and other lubricating parts fully lubricated a necessary step, the lack of her, may lead to bearings in the slip tile, or bearing oil seal broken.
Dry mortar equipment
Fourth, lubrication, just after the commissioning and installation of equipment, because it is in the equipment break-in period, the general requirements of the equipment daily lubrication, must each lubrication point both, horizontal machine to lift the motor side of the bearing as the focus, floor type machine to mixer motor support seat bearing as the focus.
Fifth, according to the production capacity of the equipment required to produce, such as mixing volume a party of equipment, mortar many can only mix a ton of mortar, light materials mixing 0.6 square, such as putty powder. Otherwise it will cause problems such as burning motor, bad bearing, broken mixing shaft and so on equipment.
Sixthly, when loading the elevator, lighter specific gravity materials, such as cement, are used first, followed by heavier specific gravity materials, such as sand. This can guarantee the service life of the dry mortar equipment to a great extent.