A few points about the usual maintenance of dry mortar equipment

A few points about the usual maintenance of dry mortar equipment

After the daily use of dry mortar equipment to pay attention to the following maintenance details for you to say
1. regular lubrication according to the lubrication parts. The electric drum is filled with lubricating oil according to its requirements.
2. dry mortar equipment using water weighing into the water pipeline to clean the residual concrete mixing host, such as lumps, should be immediately removed (pay special attention to the discharge door and mixing cylinder, blade and liner plate between the lumps, check the host cover and cement weighing even interface, and dust collector even interface whether there is blockage of the orifice lumps.
3. Check the fastening bolts of each department, especially the mixing tank seat, blade and liner plate, to avoid loosening.
4. If the wear between the mixing blade and the lining plate is too large, it should be adjusted to 3-5mm.
5. Check the electrical appliances: check the travel switch, contactor contact, etc., and repair or replace the defective parts in time.
6. Check the belt runout frequently and adjust it when necessary.
7. After each shift of work during the freezing season, the water supply system should be discharged from all parts of the storage water.
8. For maintenance, repair and troubleshooting of rotating parts, the main gate must be disconnected before work can be carried out.